Designed with fios Ni80 de alta qualidade (28GA x 2 + 38GA) e cuidadosamente manufactured by Fumytech, estas 10 coils Fused Clapton RDL fornecem uma performance de topo. Cada coil possui 3mm de diâmetro e 0.50Ω (aprox. 0.25Ω in dual coil), entregando vapor equilibrado, exceptional flavour e aquecimento rápido.

As coils (coils) they come pre-set in a practical package box of 10 units, garantindo protection, organization and safety during transport. Compatible with several atomizers RDA and RTA RDL/DL, these premium coils offer prolonged durability and extreme consistency, preserving the pure flavour of the liquids.

When used in setups dual coil (two coils), the combined value will be approximately 0.25Ω, allowing an excellent vapor production. It is essential to respect the appropriate power for each coil, avoiding premature wear and ensuring the safety and longevity of your device.

Product Details

• Manufacturer: Fumytech
• Material: Ni80 (28GA x 2 + 38GA)
• Format: Fused Clapton, 3mm
• Resistance: Approx. 0.50Ω (dual coil setup: approx. 0.25Ω)
• Ideal Use: Balanced RDL/DL vaping, excellent flavour and dense vapor.
• Vaping Style: RDL (Direct Lung Restricted) / DL
• Differential: Box with 10 units, pure flavour and fast heating
• Compatibility: RTA and RDA RDL/DL atomizers
• Safety, Quality and Legality Guarantee: Product in full compliance with applicable standards

Benefits

• Box with 10 units: savings and extended stock for your daily life.
• Balanced and flavorful vapor for a top RDL experience
• Crystal-clear flavour that preserves the essence of the e-liquid
• Fast heating with extended durability and consistent performance
• Compatible with medium and high-power atomizers
• Protection and organization: coils   stored in dedicated box
• Dual coil: combined value of about 0.25Ω, for warmer setups and dense clouds

Package contents

• 10 ×Fused Clapton RDL Ni80 Resistors 3mm Fumytech (Approx. 0.50Ω)

Usage Instructions

1. Place the coil in the atomizer
   Open your atomizer (RDA or RTA) and install the coil in the indicated location. Make sure the screws are tightened well.
2. Prepare the wick
   Cut a piece of quality cotton and thread it through the 3mm core of the coil. The cotton should be comfortable, not too tight.
3. Wick the cotton with e-liquid
   Apply a few drops of e-liquid to the cotton before closing the atomizer to avoid initial dry hits.
4. Gradual heating (light dry burn)
   Turn on your mod at low power and perform small activations without inhaling to stabilize the coil and remove hot spots.
5. Adjust the power properly
   Use moderate power suitable for 0.50Ω coils in single or 0.25Ω in dual coil, gradually increasing until you find your ideal point.
   
6. Vape safely
   Always respect battery discharge limits and the airflow of the atomizer.