Developed with high-quality Ni80 wires (30GA x 2 + 42GA) and carefully manufactured by Fumytech, these 10 Micro Fused Clapton MTL (New Version) provide top-tier performance. Each coil has a 2.5mm diameter and 0.88Ω (approx. 0.44Ω in dual coil), delivering smooth vapor, pure and intense flavor, and fast heating.

As coils (resistências) come packaged in a practical 10-unit box, ensuring protection, organization and safety during transport. Compatible with various atomizers RDA and RTA MTL/RDL, these premium coils offer prolonged durability and extreme consistency, faithfully preserving the flavor of your e-liquids.

When used in setups dual coil (two resistances), the combined value will be approximately 0.44Ω, enabling exceptional performance. It is essential to respect the appropriate wattage for each coil, avoiding premature wear and ensuring safety and longevity of your equipment.

Product Details

• Manufacturer: Fumytech
• Material: Ni80 (30GA x 2 + 42GA)
• Format: Micro Fused Clapton (New Version), 2.5mm
• Resistance: Approximately 0.88Ω (dual coil setup: approx. 0.44Ω)
• Ideal Use: MTL vaping focused on pure flavor, classic draw and excellent nuance retention.
• Vaporization Style: MTL (mouth-to-lung) / restricted RDL
• Differential: Box with 10 units, clear flavor and fast heating
• Compatibility: MTL RTA and MTL RDA atomizers
• Safety, Quality and Legality Guarantee: Product in full compliance with applicable standards

Benefits

• Box with 10 units: economy and extended stock for your daily use.
• Pure and crystal-clear flavor for a top MTL experience
• Low liquid consumption with excellent aroma definition
• Fast heating with prolonged durability and consistent performance
• Compatible with reference MTL atomizers
• Protection and organization: coils stored in dedicated box
• Dual coil: combined value of about 0.44Ω, for versatile setups

Package Contents

• 10 × Micro Fused Clapton MTL Ni80 2.5mm New Version Fumytech Resistances (Approximately 0.88Ω)

Usage Instructions

1. Place the resistance in the atomizer
   Open your MTL atomizer (RDA or RTA) and install the resistance in the indicated place. Make sure the screws are tightened well.
2. Prepare the cotton (wicking)
   Cut a piece of quality cotton and pass it through the 2.5mm core of the resistance. The cotton should be comfortable, without crushing the wire.
3. Dip the cotton with e-liquid
   Apply a few drops of e-liquid onto the cotton before closing the atomizer to avoid initial burning.
4. Warm up gradually (light dry burn)
   Turn your mod to low power and perform small activations without inhaling to stabilize the coil and remove hot spots.
5. Set the power correctly
   Use low/medium power appropriate for 0.88Ω coils in single or 0.44Ω in dual coil, gradually increasing until you find your ideal point.
   
6. Vape safely
   Always respect battery discharge limits and the restricted airflow of the MTL atomizer.