Ideal for vapers who prefer to build their own resistances to measure, the Coilology MTL Fused Clapton wire is manufactured in high-quality Ni80 (Nichrome). With a dual wire configuration in 30ga wrapped by an extremely thin outer wire of 40ga, it presents an approximate resistance of 3.26Ω per foot (ft).

Designed specifically for mouth-to-lung (MTL) vaping, this wire provides an extremely fast ramp-up time and a rich, clean and detailed flavor restoration. It allows full freedom to cut and shape the exact number of turns intended for the deck of your MTL RTA or MTL RDA atomizer.

It is fundamental to respect the appropriate power for the built final resistance value, ensuring safe vaporization and prolonging the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Coilology
• Material: Ni80 (Nichrome)
• Wire Type: MTL Fused Clapton (Coil / Spool)
• Wire Configuration: 2-30ga / 40ga
• Resistance Linear: Approx. 3.26Ω per foot
• Vaporization Style: MTL (Mouth to Lung) / restricted DL
• Differential: Complex wire in a coil for creating personalized coils with ultra-fast heating and exceptional flavor
• Compatibility: RTA and MTL RDA atomizers
• Safety, Quality and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Total building freedom: cut and shape the resistances to the desired size and ohm value
• Optimized Fuse Clapton structure for MTL (2-30/40ga)
• Fast heating and superior reactivity thanks to Ni80 wire
• Pure, rich and detailed flavor ideal for tobacco and fruity e-liquids
• Protection and organization: wire coiled in a dedicated spool

Package Contents

• 1 × Coilology MTL Fused Clapton Ni80 Wire Spool (2-30/40ga, 3.26Ω/ft)

Usage Instructions

1. Cut the desired length
   Use an appropriate tool to cut a wire segment based on the number of wraps and diameter intended for your coil.
2. Temper the resistance
   Wrap the wire in a coil building kit (coil jig) — typically with a diameter of 2.0mm or 2.5mm for MTL — to form the spiral.
3. Install and secure in the atomizer
   Place the coil in the deck of your RTA or MTL RDA atomizer and firmly tighten the screws. Always check the ohms value on a mod or ohm reader.
4. Heat at low power (gentle dry burn)
   Do short activations and reduced power to stabilize the coil, eliminate hotspots, and even the glow from inside out.
5. Insert the cotton and adjust the power
   Comfortably thread the cotton, moisten with e-liquid, and use the mod within the power range suitable for the final constructed resistance.
   
6. Vape safely
   Replace the wire and cotton periodically to maintain maximum performance and flavor purity.