Ideal for vapers who prefer to build their own custom coils, the wire coil Coilology MTL Fused Clapton is manufactured in high-quality Ni80 (Nichrome). With a double wire configuration in 30ga surrounded by an extremely thin outer wire of 40ga, it presents an approximate resistance of 3.26Ω per foot (ft).

Specifically designed for mouth-to-lung (MTL) vaping, this wire provides a extremely fast ramp-up time and a rich, clean, and detailed flavor restoration . Allows complete freedom to cut and shape the exact number of turns intended for the deck of your MTL RTA or RDA atomizer. Allows total freedom to cut and shape the exact number of wraps intended for the deck of your RTA or MTL RDA.

It is essential to respect the appropriate power for the final built resistance value, ensuring safe vaping and prolonging the life of cotton and your equipment.

Product Details

• Brand / Manufacturer: Coilology
• Material: Ni80 (Nichrome)
• Wire Type: MTL Fused Clapton (Coil / Spool)
• Winding Configuration: 2-30ga / 40ga
• Resistance: Approximately 3.26Ω per ft
• Vaping Style: MTL (Mouth to Lung) / restricted RDL
• Differential: Complex wire coil for creating personalized coils with ultra-fast heating and exceptional flavor
• Compatibility: MTL RTA and RDA atomizers
• Safety, Quality and Legality Assurance: Original product in full compliance with applicable standards

Benefits

• Total build freedom: cut and shape the coils to the desired size and ohm value
• Optimized Fused Clapton structure for MTL (2-30/40ga)
• Rapid heating and superior responsiveness thanks to Ni80 wire
• Pure, rich, and detailed flavor ideal for tobacco and fruity e-liquids
• Protection and organization: wire   packed in a dedicated coil

Package contents

• 1 × Coilology MTL Fused Clapton Ni80 Wire Coil

Usage Instructions

1. Cut the desired length
   Use an appropriate tool to cut a strand of wire based on the number of turns and diameter intended for your coil
2. Shape the coil
   Wrap the wire around a build kit (coil jig) — typically with a diameter of 2.0 mm or 2.5 mm for MTL — to form the spiral
3. Install and secure in the atomizer
   Place the coil on the deck of your MTL RTA or RDA and firmly tighten the screws. Always check the ohms value on a mod or an ohm reader
4. Warm up at low power (gentle dry burn)
   Perform short activations at reduced power to stabilize the coil, eliminate hotspots and even the glow from inside out
5. Insert the cotton and adjust the power
   Comfortably thread the cotton, saturate with e-liquid and use the mod at the appropriate power range for the final constructed resistance
   
6. Vape safely
   Replace the wire and cotton periodically to maintain maximum performance and flavor purity