Desenvolvida pela prestigiada marca Vandy Vape, a bobine de 3 metros de fio Ni80 Fused Clapton oferece uma solução de topo para vapers que preferem criar as suas próprias resistências personalizadas. Com uma geometria de dois núcleos internos em 28ga envolvidos por um fio exterior ultrafino de 35ga, maximiza a área de superfície de aquecimento.

Fabricado inteiramente em Ni80 (Nichrome) de alta qualidade, este fio garante um tempo de resposta (ramp-up time) extremamente rápido e uma restituição de sabor excecionalmente rica, limpa e detalhada. A bobine de 3 metros assegura stock prolongado para múltiplas construções em atomizadores RTA e RDA.

It is essential to respect the appropriate power to the final resistance value built, ensuring safe vaporization, excellent thermal stability, and prolonging the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Vandy Vape
• Material: Ni80 (Nickel-Chromium)
• Wire Type: Fused Clapton (3 Meter Coil / Spool)
• Wiring configuration: 28ga × 2 / 35ga
• Coil length: 3 meters
• Vaping style: DL / RDL (Direct Lung and Restricted Lung)
• Differential: High-performance complex wire with ultra-fast heating and superior flavor
• Compatibility: RTA and RDA atomizers
• Safety, Quality and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Generous 3-meter coil: extended autonomy for numerous builds
• Two-core fused Clapton geometry for larger surface area and dense vapor
• Instant responsiveness (fast ramp-up time) thanks to Ni80 material
• Rich, deep and detailed flavor that enhances all notes of the e-liquid
• Protection and organization: coil packaged in dedicated Vandy Vape packaging

Packaging Contents

• 1 × 3 Meters of Vandy Vape Ni80 Fused Clapton Wire Coil (28ga*2 + 35ga)

Usage Instructions

1. Cut to the desired length
   Use an appropriate tool to cut a segment of wire based on the number of wraps and the diameter intended for your coil.
2. Shape the resistance
   Wrap the wire around a build kit (coil jig) to form the spiral with the desired inner diameter (e.g., 2.5mm or 3.0mm).
3. Install and secure into the atomizer
   Place the coil in the deck of your RTA or RDA and tighten the screws firmly. Always check the ohm value on a mod or ohm reader.
4. Heat at low powers (soft dry burn)
   Make short activations at reduced powers to stabilize the coil, eliminate hotspots and even out the brightness from inside out.
5. Insert the cotton and adjust the power
   Fit the cotton comfortably, moisten with e-liquid and use the mod in the power range appropriate for the final built resistance.
   
6. Vape safely
   Replace the wire and cotton periodically to maintain maximum performance and flavor purity.