Developed specifically for mouth-to-lung (MTL) vaping enthusiasts, the Vandy Vape Fine MTL Fused Clapton wire is made from high-quality Ni80 (Nichrome). Conceived with extremely thin internal cores wrapped by a microscopic outer sleeve, this wire guarantees an ultra-fast ramp-up time and an exceptionally rich, clean, and detailed flavor restitution.

Allows total freedom to cut and shape the exact number of turns desired for the deck of your MTL RTA or RDA, delivering superior performance with tobacco- or fruity-flavored e-liquids.

It is essential to respect the appropriate wattage for the final built resistance value, ensuring safe vaping, excellent thermal stability, and prolonging the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Vandy Vape
• Material: Ni80 (Nichrome)
• Wire Type: Superfine MTL Fused Clapton (Coil / Spool)
• Vaping Style: MTL (Mouth to Lung) and restricted RDL
• Differential: Ultra-fine wires of high precision for immediate reactivity and superior flavor in MTL atomizers
• Compatibility: RTA and MTL RDA Atomizers
• Safety, Quality and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Total freedom to build: cut and shape the coils to the desired size and ohm value
• Optimized Superfine Fused Clapton geometry for MTL
• Ultra-fast heating (immediate ramp-up time) thanks to the Ni80 material
• Pure, rich and detailed flavor ideal for extracting all notes from complex e-liquids
• Protection and organization: wire coiled in a dedicated Vandy Vape spool

Packaging contents

• 1 × Vandy Vape Superfine MTL Fused Clapton Ni80 Wire Coil

Usage Instructions

1. Cut the desired length
   Use an appropriate tool to cut a segment of wire based on the number of turns and diameter intended for your coil.
2. Shape the resistance
   Wrap the wire around a coil building kit — usually with a diameter of 2.0mm or 2.5mm for MTL — to form the spiral.
3. Install and secure in the atomizer
   Place the coil in the deck of your RTA or MTL RDA atomizer and tighten the screws firmly. Always verify the ohm value on a mod or ohmmeter.
4. Heat at low powers (soft dry burn)
   Perform short activations at reduced powers to stabilize the coil, eliminate hotspots and even out the brightness from inside out. Note: Because this is an ultra-thin Ni80 wire, it heats up very quickly; avoid excessive reddening.
5. Insert the cotton and adjust the power
   Pull the cotton comfortably, dampen with e-liquid and use the mod in the power range appropriate to the final resistance built.
   
6. Vape safely
   Replace the wire and the cotton periodically to maintain maximum performance and flavor purity.