Developed with high-quality Ni80 wires (30GA x 2 + 42GA) and carefully manufactured by Fumytech, these 10 Micro Fused Clapton MTL resistors (New Version) provide a top-tier performance. Each resistor has a 2.5mm diameter and 0.88Ω (approx. 0.44Ω in dual coil), delivering smooth vapor, pure and intense flavour, and rapid heating.

The coils (coils) come packaged in a practical box of 10 units, ensuring protection, organization and safety during transport. Compatible with various atomizers RDA and RTA MTL/RDL, these premium coils offfer premium?long-lasting durability and extreme consistency, faithfully preserving the flavour of your e-liquids.

When used in setups dual coil (two coils), the combined value will be approximately 0.44Ω, allowing for a exceptional performance. It is essential to respect the appropriate power for each coil, avoiding premature wear and ensuring safety and longevity of your equipment.

Product Details

• Manufacturer: Fumytech
• Material: Ni80 (30GA x 2 + 42GA)
• Format: Micro Fused Clapton (New Version), 2.5mm
• Resistance: Approx. 0.88Ω (dual coil setup: approx. 0.44Ω)
• Ideal Use: MTL vaporization focused on pure flavour, traditional draw and excellent nuance retention.
• Vaporization Style: MTL ( Mouth to Lung ) / restricted RDL
• Differential: Box with 10 units, crystal flavour and rapid heating
• Compatibility: RTA and MTL RDA atomizers
• Safety, Quality and Legality Guarantee: Product in full compliance with applicable standards

Benefits

• Box with 10 units: economy and extended stock for your daily use.
• Pure and crystal flavour for a top MTL experience
• Low liquid consumption with excellent aroma definition
• Rapid heating with prolonged durability and consistent performance
• Compatible with reference MTL atomizers
• Protection and organization: coils   stored in dedicated box
• Dual coil: combined value of around 0.44Ω, for versatile setups

Package contents

• 10 ×Micro Fused Clapton MTL Ni80 2.5mm New Version Fumytech (Approx. 0.88Ω)

Instructions for Use

1. Install the coil in the atomizer
   Open your MTL atomizer (RDA or RTA) and install the coil in the indicated place. Make sure the screws are tightened well.
2. Prepare the cotton (wicking)
   Cut a piece of quality cotton and thread it through the 2.5mm core of the coil. The cotton should be comfortable, without crushing the wire.
3. Wet the cotton with e-liquid
   Apply a few drops of e-liquid to the cotton before closing the atomizer to avoid initial burning.
4. Gradually heat (light dry burn)
   Turn your mod on at a low power and make short activations without inhaling to stabilize the coil and remove hot spots.
5. Set the power correctly
   Use low/moderate power appropriate for 0.88Ω coils in single or 0.44Ω in dual coil, gradually increasing until you find your ideal point.
   
6. Vape safely
   Always respect the battery discharge limits and the restricted airflow of the MTL atomizer.