Pegasus Coils Rods Boson

4 Wires in Rod to make your own Pegasus Coils resistance, Alien Interlock Boson, so you can design what you like best.

High-quality materials, such as the line used from Genuine Sandvik Kidney Puncher.

Features:
Material Ni 80
Triple-core configuration with 2 clapton
5 turns at 2.5 Ø are usually around 0.11 dual and 0.22 single (approximately).
5 turns at 3 Ø are usually around 0.14 dual and 0.28 single (approximately).

Recommendations:

Place the resistances in the tank/atomizer without tightening them completely.

Give small pulses with power between 15 and 20 watts in sequence so they start to heat, then go up, gradually increasing the power while tightening the screws on the coil to finish stabilizing.

Wash the coils with water or an ultrasonic bath, dry them, then place the cotton and once placed, wet with liquid on the coils so the cotton is well saturated and ready to vaporize.

To purchase Tools CLICK HERE

To purchase Cotton CLICK HERE