Created by the prestigious brand Vandy Vape, the 3-meter SS316 Fused Clapton wire coil combines the purity of stainless steel with a complex high-performance geometry. Available in advanced configurations of two inner cores wrapped by an ultra-fine outer wire — 24GA × 2 + 32GA or 26GA × 2 + 30GA —, this wire maximizes surface area for massive, flavorful vaporization.

Made in Stainless Steel (SS316), it guarantees fast heating, excellent durability, and total versatility, allowing use in both variable wattage (VW) mode and temperature control (TC). The 3-meter coil provides extended autonomy for multiple custom builds in RTA and RDA atomizers.

It is fundamental to respect the appropriate power for the final resistance value built, ensuring safe vaporization and prolonging the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Vandy Vape
• Material: Stainless Steel (SS316)
• Wire Type: Fused Clapton (3 Meters / Spool)
• Available Configurations: 24GA × 2 + 32GA or 26GA × 2 + 30GA
• Coil Length: 3 Meters
• Vaporization Style: DL / RDL (Direct Lung High-Vape)
• Differential: Fused Clapton Structure in Stainless Steel for power mode or temperature control and dense vapor
• Compatibility: Advanced RTA and RDA atomizers
• Safety, Quality, and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Generous 3-meter Coil: extended autonomy for countless customized builds
• Fused Clapton Geometry in Stainless Steel for clean flavor and efficient heating
• Compatible with Temperature Control (TC) or Variable Wattage (VW)
• Massive surface area that extracts maximum yield from complex e-liquids
• Protection and organization: coil packaged in dedicated Vandy Vape packaging

Package Contents

• 1 × 3 Meters of Vandy Vape SS316 Fused Clapton Wire (Selected Configuration: 24GA*2 + 32GA or 26GA*2 + 30GA)

Usage Instructions

1. Cut the desired length
   Use an appropriate tool to cut a segment of wire based on the number of wraps and the diameter intended for your coil.
2. Shape the resistance
   Wrap the wire into a build kit (coil jig) to form the helix with the desired inner diameter (e.g., 2.5mm or 3.0mm).
3. Install and secure in the atomizer
   Place the coil in the build deck of your RTA or RDA and tighten the screws firmly. Always check the ohms value on a mod or ohm reader.
4. Heat at low power (gentle dry burn)
   Make short activations and run at reduced power to stabilize the coil, eliminate hotspots, and even out the glow from inside out. Note: Stainless Steel heats up very quickly, avoid over-browning.
5. Insert the cotton and adjust the power
   Loosely insert the cotton, soak with e-liquid, and use the mod within the appropriate power range for the final resistance built.
   
6. Vape safely
   Replace the wire and cotton periodically to maintain maximum performance and flavor purity.