Created by the prestigious brand Vandy Vape, the 3 meter wire coil SS316 Fused Clapton combines the purity of Stainless Steel with a high-performance complex geometry. Available in advanced configurations of two internal cores wrapped by an ultra-thin outer wire —24GA × 2 + 32GA or 26GA × 2 + 30GA —, this wire maximizes surface area for massive vaporization and rich flavour.

Manufactured in Stainless Steel (SS316), guarantees rapid heating, excellent durability, and total versatility, allowing use in both variable wattage (VW) mode and temperature control (TC). The 3 meter coil ensures extended autonomy for multiple custom builds in RTA and RDA atomizers.

It is essential to respect the appropriate power level for the final constructed resistance value, ensuring safe vaporization and prolonging the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Vandy Vape
• Material: Stainless Steel (SS316)
• Wire Type: Fused Clapton (3 Meter Coil / Spool)
• Available Configurations: 24GA × 2 + 32GA or 26GA × 2 + 30GA
• Coil Length: 3 Meters
• Vaping Style: DL / RDL (High-output Direct Lung)
• Differential: Fused Clapton structure in Stainless Steel for wattage mode or temperature control and dense vapor
• Compatibility: Advanced RTA and RDA atomizers
• Safety, Quality and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Generous 3-meter coil: extended autonomy for numerous customized builds
• Fused Clapton Geometry in Stainless Steel for clean flavour and efficient heating
• Temperature Control (TC) compatibility or variable wattage (VW)
• Massive surface area that extracts maximum performance from complex e-liquids
• Protection and organization: coil   packaged in dedicated Vandy Vape packaging

Package contents

• 1 × ;3 Meters Coil of Vandy Vape SS316 Fused Clapton Wire (Selected Configuration: 24GA*2 + 32GA or 26GA*2 + 30GA)

Usage Instructions

1. Cut the desired length
   Use an appropriate tool to cut a segment of wire based on the number of wraps and diameter intended for your coil.
2. Form the resistance
   Wrap the wire around a coil jig to form the coil with the desired internal diameter (e.g., 2.5mm or 3.0mm).
3. Install and secure in the atomizer
   Place the coil on the deck of your RTA or RDA atomizer and tighten the screws firmly. Always check the ohm value on a mod or ohm reader.
4. Heat at low power (gentle dry burn)
   Do short activations at reduced power to stabilize the coil, eliminate hotspots, and even out glow from inside to outside. Note: Stainless Steel heats up very quickly, avoid excessive reddening.
5. Insert the cotton and adjust the power
   Thread the cotton comfortably, dampen with e-liquid, and use the mod at the appropriate power range for the constructed resistance.
   
6. Vape safely
   Replace the wire and cotton periodically to maintain maximum performance and flavour purity.