Produced by the renowned brand Vandy Vape, the resistive wire in Stainless Steel (Stainless Steel SS316L) the gauge 24GA is an excellent choice for vapers who prefer to build their own wires in simple wire (round wire). SS316L stands out for excellent reactivity, exceptional flavour purity, and full compatibility with both variable wattage mode (VW) and temperature control (TC).

With a diameter of 24GA (0.50mm), this wire offers a perfect balance between thermal stability and dense vapor production, making it ideal for DL-focused RTA and DL/RDL high-performance atomizers. It guarantees complete freedom to shape the exact number of turns and the desired diameter for your device's deck.

It is essential to respect the appropriate power for the final build resistance value, ensuring safe vaping, excellent stability, and extending the life of the cotton and your equipment.

Product Details

• Brand / Manufacturer: Vandy Vape
• Material: Stainless Steel SS316L (low-carbon Stainless Steel)
• Wire Type: Round Wire / Single Wire (Coil / Spool)
• Gauge: 24GA (0.50mm)
• Vaporization Style: DL and MTL (Direct Lung and Mouth-To-Lung)
• Difference: Compatibile with Temperature Control (TC) and VW, quick heating and clean flavour
• Compatibility: RTA, RDA and RDTA atomizers
• Safety, Quality and Legality Guarantee: Original product in full compliance with applicable standards

Benefits

• Total freedom of construction: cut and mold the coils to the size and ohm value desired
• Versatile 24GA gauge for excellent balance between vapor and flavour in DL/RDL
• Genuine SS316L material for power mode or temperature control with low carbon content
• Clean, faithful flavour with no metallic interference
• Protection and organization: wire   packed in dedicated Vandy Vape coil

Package contents

• 1 × Vandy Vape Stainless Steel SS316L Wire Coil 24GA

Usage Instructions

1. Cut to the desired length
   Use an appropriate tool to cut a segment of wire based on the number of turns and diameter intended for your coil.
2. Form the coil
   Wrap the wire into a construction kit (coil jig) to form the spiral with the desired inner diameter (e.g., 2.5mm or 3.0mm).
3. Install and secure in the atomizer
   Place the coil in the deck of your RTA or RDA atomizer and tighten the screws firmly. Always check the ohms value on a mod or ohm reader.
4. Heat at low power (gentle dry burn)
   Perform short activations at reduced power to stabilize the coil, eliminate hotspots, and even the glow from inside out. Note: Stainless Steel heats up very quickly; avoid excessive reddening.
5. Insert the cotton and adjust the power.
   Pass the cotton comfortably, moisten with e-liquid, and use the mod within the power range appropriate for the final coil built.
   
6. Vape safely.
   Replace the wire and cotton periodically to maintain maximum performance and flavour purity.